Name:	LonghornBoater -	Reply
Subject:	Trim issue
Date:	6/14/2016 2:24:35 PM

Just purchased a 2007 5.0/Alpha Sea Ray Select with only 17.6 hours. All works great except the trim. It will move both up and down but travel is well short of the full up position. Trim was fine until today.

Name:	CAT BOAT -	Reply
Subject:	Trim issue
Date:	6/15/2016 4:32:59 PM

Make sure there is not an extra UP/Trailer button on the lever/control.  Also make sure you are pushing the UP switch hard enought to make it click again.  What you are experiencing is the TRIM LIMIT unit located at the pivot point on the alpha drive.  Call me and I will explain.

Steve

Name:	LonghornBoater -	Reply
Subject:	Trim issue
Date:	6/15/2016 5:18:30 PM

Thanks for the response, I began thinking about the SmartCraft settings after I posted. I will be back down at the boat Friday and plan to run through the calibration process then.