Forum Thread
(Smith Lake Specific)
2,155 messages
Updated 6/25/2024 8:47:10 AM
Lakes Online Forum
84,091 messages
Updated 11/8/2024 10:28:12 AM
Lakes Online Forum
5,204 messages
Updated 9/14/2024 10:10:50 AM
(Smith Lake Specific)
61 messages
Updated 11/13/2022 9:38:51 PM
Lakes Online Forum
4,172 messages
Updated 9/9/2024 5:04:44 PM
Lakes Online Forum
4,262 messages
Updated 11/6/2024 6:43:09 PM
Lakes Online Forum
2,979 messages
Updated 6/26/2024 5:03:03 AM
Lakes Online Forum
98 messages
Updated 4/15/2024 1:00:58 AM
Smith Lake Photo Gallery





    
Name:   roswellric - Email Member
Subject:   Suggestions?
Date:   10/5/2012 11:44:27 AM

I'm going to build an addition to my wood deck to accommodate my assortment of grills and smokers. The usual 3/4 wood deck floor is worrysome from a fire hazard standpoint. Any of you guys have a suggestion to a material that could be substituted for the 3/4 decking?



Name:   Summer Lover - Email Member
Subject:   Nomex carpet
Date:   10/5/2012 2:01:41 PM

Are you concerned that a grill/smoker might get knocked over? Decks at both the house and cabin are 5/4 boards, and have not had any issues. You may want to lay down some Wonderboard, ceramic tile and use thresholds under the grills..,



Name:   roswellric - Email Member
Subject:   Nomex carpet
Date:   10/5/2012 3:44:33 PM

For my charcoal workhorse I use a Weber and I get sparks through the vent holes occasionally. I have trees and get leaves up under the deck so I'm concerned about ignition under the deck. Hard to get under the deck to clean it out too. I thought some surface that could be hosed off would be convenient too.



Name:   Summer Lover - Email Member
Subject:   Nomex carpet
Date:   10/5/2012 4:04:19 PM

I use a generic grill mat at the house - is supposed to be flame and oil resistant... Another option would be to put metal roofing under the deck (attach to the floor joists) - angle down on the outside edge to allow drainage, this would also give you semi-dry storage.



Name:   roswellric - Email Member
Subject:   Nomex carpet
Date:   10/5/2012 4:58:23 PM

Now there's a thought...Thanks!



Name:   Ulysses E. McGill - Email Member
Subject:   Suggestions?
Date:   10/9/2012 9:17:50 AM

I did my whole deck in tile a few years ago....no worries about fire, leaves and pine straw don't fall through or get stuck between boards, no staining, and easy cleaning.




Name:   roswellric - Email Member
Subject:   Suggestions?
Date:   10/9/2012 10:10:20 AM

What did you use for the underlayment?



Name:   blmeanie - Email Member
Subject:   Suggestions?
Date:   10/9/2012 2:48:33 PM

pictures of the tile deck?



Name:   Ulysses E. McGill - Email Member
Subject:   Suggestions?
Date:   10/10/2012 1:18:55 AM

Here is a picture in progress. First we reinforced the joists and sloped the framing while doing so.Then primed 3/4 inch tongue and grove plywood was screwed down. plywood was covered with roofing felt. 5/8" Durock was layered over felt and screwed down. Joints were taped and a layer of thin set was added. Thin set was painted with a rubber type coating made for tile wet areas and showers (providing a water tight barrier). Tile was set directly on the coating and grouted.


Below is the finished product





Name:   Ulysses E. McGill - Email Member
Subject:   The finished product
Date:   10/10/2012 1:23:10 AM (updated 10/10/2012 1:25:55 AM)





Name:   Ulysses E. McGill - Email Member
Subject:   Here are a few pictures through the project
Date:   10/10/2012 1:44:44 AM





Name:   lakngulf - Email Member
Subject:   Here are a few pictures through the project
Date:   10/10/2012 9:53:10 AM

Where is the picture of your arm in a bind?



Name:   Ulysses E. McGill - Email Member
Subject:   Here are a few pictures through the project
Date:   10/10/2012 1:21:51 PM (updated 10/10/2012 1:23:23 PM)

You have to look at facebook for that one.....it happened within about an hour of taking the second picture in the last set. I was trying to slide that piece of plywood (middle of the picture under the glue tubes) when the tendon snapped.



Name:   roswellric - Email Member
Subject:   Thanks Guys!
Date:   10/19/2012 7:42:48 AM (updated 10/19/2012 7:44:43 AM)

Some might good suggestions. McGill ...very impressive. I'm not in your league but I might get some good ideas there/. Thanks for the pics!







Quick Links
Smith Lake News
Smith Lake Photos
Smith Lake Videos




About Us
Contact Us
Site Map
Search Site
Advertise With Us
   
www.SmithLake.info
THE SMITH LAKE WEBSITE

Copyright 2024, Lakes Online
Privacy    |    Legal