(Lake Lanier Specific)
149 messages
Updated 2/24/2023 6:27:46 AM
Lakes Online Forum
83,915 messages
Updated 9/7/2024 7:52:09 AM
Lakes Online Forum
5,200 messages
Updated 8/23/2024 12:20:47 PM
(Lake Lanier Specific)
3 messages
Updated 7/28/2021 3:19:01 PM
Lakes Online Forum
4,171 messages
Updated 6/27/2024 7:05:46 AM
Lakes Online Forum
4,261 messages
Updated 5/28/2024 6:31:10 AM
Lakes Online Forum
2,979 messages
Updated 6/26/2024 5:03:03 AM
Lakes Online Forum
98 messages
Updated 4/15/2024 1:00:58 AM
|
|
|
Name: |
Maverick
-
|
|
Subject: |
Trolling Motor Questions
|
Date:
|
7/6/2006 2:57:28 PM
|
Minn Kota or Motor Guide?
Thrust for 16' Aluminum Monarch Bass Boat with 40 HP Motor, for Lake Martin?
Any other features/options I should get or need like, auto pilot, sonar, etc? Not really a serious fisherman by any means.
24 volt vs 12 volt? (Boat currently set up for 12 volt)
I measured the length of the old trolling motor shaft from the bottom of the top housing to the middle of the prop housing and it measures 36". so I assume I need a 36" shaft, but a lot of the Minn Kotas are like a minumum of 42" or thereabouts, are these shaft adjustable and this is the longest the shaft will extend? If not, is a 42" shaft OK, as will be longer than the current trolling motor shaft, if I measured correclty.
Any suggestions, feedback would be appreciated.
|
Name: |
GoneFishin
-
|
|
Subject: |
Trolling Motor Questions
|
Date:
|
7/6/2006 5:37:55 PM
|
Boy Mav, you asked a lot of questions for a Know It All ! I have been doing some research on a Minn Kota for our pontoon so I have sought answers to similar questions as you are asking. The following site from Minn Kota is a big help:
http://www.minnkotamotors.com/support/faq.asp?pg=general
The amount of thrust is determined by the total weight of boat, motor, gear, and passengers. I would assume with a 16ft boat that 55 lbs would be more than sufficient. You do need a seperate Deep Cycle battery for the motor so you don't run out of power and the 40hp won't start. Above 55 lbs thrust you need 24 volt or 2 batteries dedicated to the trolling motor. See chart below and try to estimate the total weight.
Unless you have a fish finder (sonar) you do not need the sonar as part of the motor. It is nice with it built in if you have a newer sonar that is compatible. The auto is nice if you plan to troll. The remote is real nice as it enables you to steer from your hand and any part of the boat. It can get tiresome using the foot pedal for an extended period of time.
I had a problem determining the shaft length/. The advertised length is just that---the shaft. It is not the full length of the motor. Rather, the exposed shaft and a small part in the bottom and top. The overall lenght is about 10-12 inches longer than the shaft. A longer shaft gives you more in the water for rough weather. You cannot shorten a motor only adjust the amount of shaft in and out of water.
How much thrust does MAV need?
In general you want to have as much thrust as possible for the times when you run into wind and current. The rule of thumb in choosing thrust is to take the total weight of the loaded boat and divide it by 70. For example, if your boat with people and gear weighs a total of 3500 lbs you will then divide that by 70. That means that ideally you should have a motor with at least 50 lbs. of thrust.
Motor Thrust Total Weight 30 lbs 2100 lbs 36 lbs 2520 lbs 40 lbs 2800 lbs 42 lbs 2940 lbs 44 lbs 3080 lbs 48 lbs 3360 lbs 50 lbs 3500 lbs 55 lbs 3850 lbs 65 lbs 4550 lbs 74 lbs 5180 lbs 101 lbs 7070 lbs
What length of shaft DOES MAV NEED?
For a bow mounted motor you take the length from the top of the bow (where the motor would be mounted) to the waterline when the boat is loaded. You then add 20 inches to that number and then round up to the next longest shaft if you have to. So, if the distance from the bow to the water is 15 inches then you will add 20 inches to that. You come up with 35 inches but find that there is no motor for the brand you want with a 35 inch shaft. Therefore, all you have to do is round up to the 36 inch shaft.
Bow to Waterline Shaft Length 0-10 inches 30 inches 11-16 inches 36 inches 17-22 inches 42 inches 23-30 inches 50 inches 31-34 inches 54 inches
The bottom line is if you are just putzing around, a hand controlled motor without any bells and whistles will suffice. Post any other questions or email me.
Rich
|
Name: |
Feb
-
|
|
Subject: |
Trolling Motor Questions
|
Date:
|
7/6/2006 6:29:53 PM
|
Maverick is going to be in Heaven with all those numbers. (LOL)
|
Name: |
Maverick
-
|
|
Subject: |
Trolling Motor Questions
|
Date:
|
7/6/2006 8:19:00 PM
|
Thanks GF - great info !!!
Feb is right I am in heaven with all those numbers to calc from.
Thanks for all the info.
|
Name: |
Lakeman
-
|
|
Subject: |
Trolling Motor Questions
|
Date:
|
7/6/2006 9:52:55 PM
|
Mav I have a 17' aluminum SeaArk bass boat and I bought a 74# thrust MiniKota and would not go back to MotorGuide. It was fairly simple to switch to 24 volts. Mine is a foot controlled. When I get old I might switch to a remote automatic.
|
Name: |
Maverick
-
|
|
Subject: |
Thanks for the Feedback
|
Date:
|
7/8/2006 1:12:12 AM
|
Thanks guys for the feedback.
Just purchased a Minn Kota 55 Edge from Academy Sports for $379.00, plus included an inexpensive fish finder to boot.
|
Name: |
MotorMan
-
|
|
Subject: |
Thanks for the Feedback
|
Date:
|
7/31/2006 1:31:50 PM
|
Remember that a 56 pound thrust 12 volt motor will draw about 56 Amps. and require #6 AWG or bigger (a smaller number like #4).
A 24 volt 55 pound motor will draw about 27 Amps and get by on #10 wire, but #8 is still better. Notice the 24 volt motor is not 56/2 or 28 amps
They have a little less "line loss" of voltage.
|
|
|