Name:	SEDS -	Reply
Subject:	Dent Repair
Date:	12/2/2022 10:32:15 PM

Anyone know of a paintless dent repair company in the area?  Have a small ding in the aluminum siding on a new pontoon boat, damit man!

Name:	Maverick -	Reply
Subject:	Dent Repair
Date:	12/5/2022 5:33:01 PM

If you have any luck let us know, as I was told Aluminum will not allow the dent to be pulled, as too soft and just a matter of time before the dent repair fails or will not work at all.

Name:	Rooster -	Reply
Subject:	Dent Repair
Date:	12/11/2022 9:21:50 AM

I bought a suction cup repair kit from autozone that works great for small dents

Name:	SEDS -	Reply
Subject:	Dent Repair
Date:	12/11/2022 11:30:16 AM

Cool thanks, I'll check it out

Name:	Rooster -	Reply
Subject:	Dent Repair
Date:	12/13/2022 6:29:33 PM

If the dent is on thin metal, might want to try a toilet bowl plunger.  Might work if you can get a good seal!

Name:	MrHodja -	Reply
Subject:	Dent Repair
Date:	12/13/2022 7:50:09 PM

You got my curiosity up so I duckduckgo'd "Paintless Dent Removal" and if the dent is in one of the thin aluminum sheets on the sides of your boat it looks like there are quite a few options that might work out well for you.  If you can't get to the back of the panel to push it out there are kits that use a hot glue gun to attach a post to the dent and a pulling device that pulls the dent out.  Just check out some of the videos.  Might not end up with a perfect job, but probably will get most of the dent out.  I have an old Expedition that has seen some rough times and may try one of these things myself.